|
|
Posted by Jeckyl on 01/24/07 10:12
> Well it works, Cupcake, but yer only getting a speed gain of about 2
> seconds. WOW, boy THAT sure was a waste of my time.
There must be a fair bit else going on (assuming 2 seconds is not
significant) .. I might have a little look at your decompiled code. I want
to see why you have so MANY copies of the same code in your movie .. maybe
there's some other optimization that can be done to speed the whole thing
up.
> my method with CASE instead of IF next and see what that gets me.
Its certain not to be faster (as its the same amount of work as the
hex-convert-plus-if-statement logic, which was much slower than my method).
... but it will at least handle cases like when red component is 0 etc.
> After that I think I'll try and see if I can get the
> ByteArray.compress() method to work...although I haven't been able to
> find any specific (in use) documentation or examples of it yet.
I've not done anything with that myself either, so I can offer no advice or
suggestions.
--
Jeckyl
Navigation:
[Reply to this message]
|