|
|
Posted by Neil on 02/14/06 22:35
Yes, you are right. All three steps are executing. There was a problem with
the data which was giving the impression that the job wasn't executing.
Thanks!
Neil
"Andrew J. Kelly" <sqlmvpnooospam@shadhawk.com> wrote in message
news:OsJ7bwNMGHA.740@TK2MSFTNGP12.phx.gbl...
> Are you sure only the first step is executing? If you right click on the
> job and choose show history, then check the checkbox to show the steps do
> you see all three or only one?
>
> --
> Andrew J. Kelly SQL MVP
>
>
> "Neil" <nospam@nospam.net> wrote in message
> news:KL5If.1367$UN.1000@newsread2.news.pas.earthlink.net...
>>I have three stored procedures that need to run nightly in SQL 7. The
>>three procedures are not related; but to keep the procedures from running
>>at the same time, I placed them as three steps of a single job. The first
>>two steps are set to "Goto next step" on success; the last step is set to
>>"Quit with success."
>>
>> The job runs every night. However, only the first step/procedure is
>> executed. Also, the first step has a green flag next to its ID in the
>> Steps tab of the job properties
>>
>> I suppose I could just call all three SPs from a single stored procedure
>> that is run nightly. But I thought that putting them as three steps in a
>> single job would cause all three to run. What am I doing wrong?
>>
>> Thanks!
>>
>> Neil
>>
>
>
Navigation:
[Reply to this message]
|